CAME ZT6 Installation Manual

All the data and information contained herein is considered subject to change at any time and at our discretion.
2
ENGLISH
The ZT6-ZT6C electrical switchboards, in the version with control and safety block buttons incorporated into the panel,
were designed to control BK2200T automations, for moving CBXT and CBYT sliding gates and for controlling drop-curtain
doors and sliding and swing gate systems.
Any use, other than the ones described above, and installations in methods other than those shown in this techni-
cal manual are considered prohibited.
WARNING - incorrect installation could cause serious injury. Follow the installation instructions carefully.
2.1 Limits of use
2
Limits of use and intended use
2.2 Intended uses
1 Symbols legend
1 Symbols legend
4
Description
Description
4.1
Three phase/single-phase electrical switchboard
Electrical switchboard for gearmotors with single-phase 230V power supply or three-phase 230/400V power supply; fre-
quency 50÷60 Hz. Fully designed and built by CAME Cancelli Automatici S.p.A. Box equipped with an air recirculation outlet.
Guaranteed for 24 months if not tampered with.
This manual was written specifically for a professional installer or other specifically trained person.
4
.3
Primary components
1 “Functions selection” Dip switch
2 2A F Accessories fuse
3 315mA Control unit fuse
4 8A F Line fuse
5 Radio frequency card connector (see table)
point 5.10
6 Radio code signal LED
7 Connecting terminal boards
8 Connecting terminal boards
transformer
9 Radio code memorizing buttons
10 TCA Trimmer: automatic closure time adju-
stment
11 Par. Op. trimmer: partial opening adjustment
3 Reference standards
4.
2
Technical information
Electrical switchboard
Supply voltage: 230V / 400V - 60 Hz
Power rating: 750W
Absorption at rest: 50 MA
Maximum power accessories, 24V : 20 W
Maximum power accessories, 230V : 85 W
The product in question is subject to the following reference standards: EN 12978, UNI EN 954-1, CEI EN 60335-1, UNI EN
12453.
Protection level: IP54
Isolation category: II
Material: ABS
Operating temperature:


+T.C.A.-
F.AP/CH2
1 2 3 4
O N
5 6 7 8
9 1 0
1

2

3

4

O N
5

6

7

8

9
9

1 0
1 0














AF
R
S
T
U
V
230V
230V
COMM.
COMM.





 

LINE FUSE
ZT6
CONTROL BOARD
CONTROL BOARD
WARNING!
This symbol denotes parts that require special attention.
This symbol denotes parts that concern safety.
This symbol denotes notes to communicate to the user.
This symbol denotes notes to communicate to the user.
This symbol denotes notes to communicate to the user.
This symbol denotes notes to communicate to the user.
This symbol denotes notes to communicate to the user.
This symbol denotes notes to communicate to the user.
This symbol denotes notes to communicate to the user.
This symbol denotes notes to communicate to the user.
7
2
3
CONTROL BOARD
4
9
6
1
O N
5
11
10
+T.C.A.-
8
8

CAME ZT6 Specifications

General

Brand	CAME
Model	ZT6
Category	Control Panel
Language	English