10
ENGINEERED VALVES
Injection Procedures
Routine Cleaning
Steps Procedure
1. Inspect valve.
Inspect:
Seat injection fittings.
Stem injection fitting. (Do not inject into this fitting.)
Body / bleed fitting
Make sure the grease gun / pump is in working order and loaded with the
appropriate product.
2. Inspect equipment.
3. Inject standard
valve flush.
Inject full seat capacity into each seat, utilizing the seat injection ports.
(Refer to capacity chart on page 13.) If this is the first time maintenance has
been performed, and the valve has been in service over two years, perform
Valve Cleaning procedures on page 11.
4. Operate valve.
Make sure it is safe to operate the valve.
Fully operate valve three times.
5. Inspect valve.
Make sure the valve is in the correct position.
Clean the grease fittings.
Replace fitting caps.
Installation, Operation and Maintenance Manual IOM-CAM-BALL-T31
To Next Page
Loading...
Need help?
General
