CAMPARK T80 - Using the T80 Trail Camera; Mode Switch and Basic Operation; Operating Buttons and Menu Navigation

7.USINGTHECAMERA
7.1.Modeswitch
Priortosettingupthecameraforsurveillance,itmustbesetupforthe
respectivepurpose.Forthispurpose,thereisasetupmodeavailable.In
additiontochangingsettings,photosandvideoscanbetakenandexisting
photoscanbeviewedinthismode.
Openthecameraasdescribedinsection6.1.TheModeswitchislocatedat
thebottomedgeontheleftinside.3operatingmodescanbeselected:
OFF:Thecameraiscompletelyswitched
offintheOFFmode.
SelectSETUPmodetoadjustSETUP:
settingsandmakeorplaybackphotosandvideos.
ThecameraisactivatedtotakephotosON:
automatically(Livemode).
7.2.Operatingbuttons
SetthemodeswitchtoSETUPandthecameraandmonitorareswitchedon.
Usingtheoperatingbuttonsdifferentfunctionscannowbeactivatedand
settingscanbechanged.Forthispurpose,thefollowingoperatingbuttons
areprovidedonthedisplaypanel:
12