CRBasic Example 2: Settings configuration and status retrieval
'"Powered up. SIM auth failure.",
'"Querying modem.",
'"Waiting for network registration.",
'"Configuring modem.",
'"Dialing.",
'"Dialing (retry).",
'"Dialed.",
'"PPP negotiation.",
'"Network ready.",
'"PPP closing.",
'"PPP paused.",
'"PPP dropped.",
'"Terminal AT command mode.",
'"Firmware update mode.",
'"Shutting down."
cell_rsrp = Settings.CellRSRP
'Reference signal received power for LTE in dbm.
'Very similar to RSSI
cell_ecio = Settings.CellECIO 'Reference signal received quality for 3G.
cell_rsrq = Settings.CellRSRQ 'Reference signal received quality for 4G.
cell_ip_address = IPInfo (1, 0)
'Get the TCP/IP address of the PPP/cellular modem interface.
CallTable CELL_DIAGNOSTICS
NextScan
EndSequence
EndProg
CELL200-Series 4G LTE Cellular Module 63
To Next Page
Loading...