Campbell CELL205 - Page 81

CRBasic Example 3: CELL200 series settings configuration and status retrieval using terminal
functionality
EndIf
SerialOut(ComSDC11, "set sdc 7" & CRLF, CRLF, 1, 200)
'Set the SDC address of the modem (7, 8, 10, 11)
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
If (returned_value = "SDC address saved. Cellular module reset required!" _
& CHR(13)) Then
modem_reset_needed = TRUE
EndIf
SerialOut(ComSDC11, "set listen port 3001" & CRLF, CRLF, 1, 200)
'Set the listen port
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
If (returned_value = "Listen port set. Reboot required!" & _
CHR(13)) Then
modem_reset_needed = TRUE
EndIf
SerialOut(ComSDC11, "set billing 10" & CRLF, CRLF, 1, 200)
'Set day of the month for billing statistics
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
SerialOut(ComSDC11, "set roaming auto" & CRLF, CRLF, 1, 200)
'Set the roaming mode of the data logger (Auto or disabled).
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
If (returned_value = "Roaming set to Auto. Cellular module reset required!"
_
& CHR(13)) Then
modem_reset_needed = TRUE
EndIf
SerialOut(ComSDC11, "set ipprotocol IPv4" & CRLF, CRLF, 1, 200)
'Set the IP protocol used on the cellular network (IPv4, IPv6, or
'IPv4/IPv6).
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
If (returned_value = "Protocol set to IPv4. Cellular module reset _
required!" & CHR(13)) Then
modem_reset_needed = TRUE
EndIf
'other set commands include:
' set ppp user (PPP username in modem)
' set ppp pass (PPP password in modem)
' set comms watch (allows user to sniff/watch a port, usually not used
' programatically)
CELL200-Series 4G LTE Cellular Module 68