Campbell CELL205 - Page 84

CRBasic Example 3: CELL200 series settings configuration and status retrieval using terminal
functionality
SerialFlush(ComSDC11)
SerialOut(ComSDC11, "show usage today" & CRLF, CRLF, 1, 200)
'Query for today's cellular data usage
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
modem_current_day_usage = returned_value
SerialFlush(ComSDC11)
SerialOut(ComSDC11, "show usage yesterday" & CRLF, CRLF, 1, 200)
'Query for yesterday's cellular data usage
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
modem_previous_day_usage = returned_value
SerialFlush(ComSDC11)
SerialOut(ComSDC11, "show usage month" & CRLF, CRLF, 1, 200)
'Query for this month's cellular data usage
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
modem_current_month_usage = returned_value
SerialFlush(ComSDC11)
SerialOut(ComSDC11, "show usage lastmonth" & CRLF, CRLF, 1, 200)
'Query for last month's cellular data usage
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
modem_previous_month_usage = returned_value
SerialFlush(ComSDC11)
SerialOut(ComSDC11, "show bat" & CRLF, CRLF, 1, 200)
'Query for last month's cellular data usage
SerialIn(returned_value, ComSDC11, 100, CHR(13), 1000)
modem_battery_voltage = returned_value
CallTable CELL_DIAGNOSTICS
NextScan
EndSequence
SlowSequence
Do
Delay(1, 5, Sec)
If(TimeIsBetween(10, 58, 60, Min) AND modem_is_off <> TRUE) Then
'make sure the modem is off at 10 minutes into
'the hour until 58 minutes into the hour
'PPPClose'Uncomment line for CR1000, CR800 series, and CR3000.
Do Until (modem_is_off = TRUE)
SerialFlush(ComSDC11)
'clean out any garbage characters that might have come in.
SerialOut(ComSDC11, CRLF , "CELL2xx>", 1, 200)
CELL200-Series 4G LTE Cellular Module 71