lower than the control when comparing baseline data with no bird spike (for summed daily
radiation on a clear sky day).
9. Troubleshooting and
maintenance
NOTE:
All factory repairs and recalibrations require a returned material authorization (RMA) and
completion of the “Declaration of Hazardous Material and Decontamination” form. Refer to
the Assistance page at the back of this manual for more information.
9.1 Maintenance and calibration
Sensor maintenance should be performed at regular intervals, depending on the desired
accuracy and the conditions of use.
1. Remove cobwebs, leaves, bird droppings, wasp nests, or other debris from the temperature
sensor (FIGURE 9-1 (p. 31)), ultrasonic transducer openings (FIGURE 9-1 (p. 31)), rain gage
funnel (FIGURE 9-2 (p. 31)), pyranometer (FIGURE 9-2 (p. 31)), and sintered glass reflection
plate (FIGURE 9-3 (p. 32)).
CAUTION:
Do not touch the temperature sensor when cleaning because it is very delicate and can
be damaged if pushed into the body.
ClimaVUE 50 Compact Digital Weather Sensor 30
To Next Page
Loading...