Campbell CR200 - List of Tables; Table 1. CR200 Series Dataloggers with Built-In Radio

Section 1. Introduction
2
Table 1. CR200 series Dataloggers with Built-In Radio
Model Frequency Where Used
CR206X
CR206 (retired)
CR205 (retired)
915 MHz U.S./Canada
CR211X
CR211 (retired)
CR210 (retired)
922 MHz Australia/Israel
CR216X
CR216 (retired)
CR215 (retired)
2.4 GHz Worldwide
The CR295X and CR295 (retired) GOES Dataloggers include an additional
9-pin serial port that allow communications with a TX320, the retired TX312, or
the retired SAT HDR GOES satellite transmitter. While the CR295 required a
special operating system, the CR295X does not.
Note: Throughout this manual CR200(X) will be used to refer to all of the
different models of datalogger in the CR200-series and CR200X-series. In the
cases where information applies only to a specific model or series of datalogger,
that will be clearly specified.
The CR200(X)-series dataloggers have the following enhanced features as
compared to the CR200-series dataloggers:
1. 128 Public variables can be used (CR200-series had 48).
2. 8 Data Tables can be declared (CR200-series had 4).
3. Compiled CRBasic program can be two times larger than for CR200-
series.
4. All CR200(X)-series CRBasic instructions are supported in a single
operating system. See CRBasic and CRBasic Help for a list of
available instructions. No new instructions have been added. If new
instructions are added in the future, they will apply only to the
CR200(X)-series dataloggers.