If possible, any USB battery charging feature on the camera should be disabled. If it cannot or
is not disabled, the CamRanger battery life will be much less.!
• Connect to the CamRanger 2 WiFi network
Turn on the CamRanger Mini and wait about 30-45 seconds for the device to initialize. When it
is ready both 2.4 GHz and 5 GHz WiFi lights will turn on.!
Go to the Settings on the iPad/iPhone and go to the WiFi settings. Select and join the WiFi
network “CamRanger-___” where the last three characters in the CamRanger serial code are
listed followed by “2.4” or “5” designating the 2.4 or 5 GHz network. In general, the 5 GHz
network should be used, though the 2.4 GHz network may
have better range. The WiFi password is the CamRanger 2
serial code in all CAPS. To the right is an example of what
your password will look like.!
• Launch app
Ensure the camera is turned on and awake and launch the CamRanger 2 app.!
CamRanger 2 App
Note: the CamRanger 2 app supports the iPad, iPhone, and iPod Touch running iOS version
9+. The layout of the app will vary slightly based on the device and orientation. However, only
a single device and orientation will be displayed here.!
To Next Page
Loading...