Nikon!
•
Connection Mode: CamRanger setting with two options PC and Camera!
•
PC: The camera is physically locked out, but more control is possible remotely.
Specifically, camera controls set with physical knobs or dials can be changed
with the CamRanger, such as drive mode, focus switch, etc.!
•
Camera: The camera can be physically controlled, but the CamRanger cannot
change as many camera settings.!
•
Exposure Preview: Camera setting that controls if the live view exposure should match
the camera’s exposure settings, or always show a reasonably exposed image. Only
higher end Nikons have this setting. Typically a photographer would want exposure
simulation off when the ambient light doesn’t match the amount of light during capture,
such as when using strobes or flashes.!
Sony!
An SD card is required in the CamRanger 2 when using a Sony camera.!
•
Remote Ctrl: Camera setting that enables the CamRanger to control the Camera. This
must be turned on.!
•
USB Connection: Camera setting that must be set to PC Remote.!
•
USB LUN Setting: Camera setting that should be set to Multi.!
•
USB Power Supply: Camera setting that controls if the camera should charge from the
USB port. Generally, this should be turned off as it will drastically reduce the
CamRanger’s battery life.!
•
Control with Smartphone: This camera setting must be turned OFF.!
•
PC Remote Settings: Camera setting that controls where images should be saved. It is
recommended to the set the Still Image Save Destination to PC+Camera. Images will be
saved to the camera’s memory and sent to the CamRanger. The recommend RAW+JPG
PC Save Image setting depends on the photographers workflow. For quick previews,
this should be set to JPEG only and the image format should be set to RAW+JPG.!
•
Exposure Step: Camera setting that controls the step size between exposure values.
Only 0.3EV is supported for changing shutter speed and ISO.!
To Next Page
Loading...