Hardware
Device
1. Ethernet Port!
2. Reset Button - Press and hold to reset device to factory settings.!
3. Battery Compartment - Refer to the battery section for more information.!
4. LEDs!
5. Charging Port - Charge with a USB micro cable.!
6. Power Switch - Press to turn on, press and hold 1-2 seconds to turn off. Press and hold
15 seconds to force power off.!
7. SD Card Port - SD/SDHC/SDHX compatible - required for Sony and Fuji!
8. USB Port - Connect camera with appropriate USB cable!
9. 1/4” 20 Socket (not pictured) - located on bottom on device for attachment to hot shoe
adapter, L-bracket, quick release plate, etc.!
The CamRanger 2 is not water resistant and should not get wet. !
To Next Page
Loading...