PROBLEMS
rmo2008-001-103_a
1. Front turn signal lens screw
2. Turn the connector counterclock-
wiseas indicatedbelow and remove
lens.
rmo2008-001-104_a
1. Front turn signal light connector
3. Remove the bulb by pushing it in
and turning counterclockwise.
4. Install the new bulb by pushing it in
and turning clockwise.
5. Properly reinstall the parts in the re-
verse order of their removal.
Turn Signal Light — Rear
1. Remove the lens with a Phillips
head screwdriver.
rmo2008-001-105_a
1. Rear turn signal lens screw
2. Remove the bulb by pushing it in
and turning counterclockwise.
3. Install the new bulb by pushing it in
and turning clockwise.
4. Reinstall the lens.
Tail Light/Brake Light
1. Remove the panel under the pas-
senger seat by unscrewing 7 Torx
screws as indicated below.
rmo2008-001-114_a
PANEL UNDER PASSENGER SEAT
1. 7 Torx screws location
2. Partially remove right rear side panel
by removing the 2 plastic rivets un-
der the seat as indicated below.
rmo2008-001-115_a
1. 2 plastic rivets under the seat
rmo2008-001-077_a
1. Flat head screwdriver under rivet head
2. Turn screwdriver 1/4 turn
112
______________
To Next Page
Loading...
Need help?
General
