BUILT-IN GAS OVENS WITH GRILL ▪ FO Series
29
FO Series – ed. 01/2020
IGNITION AND USE OF THE DEVICE IN OVEN MODE
The ignition of the oven burner must always occur with the door of the oven cavity open, according
to the following operating procedure:
Press the control knob and rotate it
counter clockwise (until you reach
the IGNITION point – 90° ANGLE from
OFF).
After 3 seconds, operate the
electronic ignition device by fully
pressing the power button next to the
control knob
After switching on, keep the control
knob firmly pressed for another 5
seconds (always keeping it at the MIN
mark) and then release it, adjusting
the temperature desired. The device
can reach a maximum temperature
of 200° C
Note: this release delay is used to
heat the safety thermocouple.
If upon releasing of the knob, the burner won’t stay lit, it means the thermocouple was not sufficiently
pre-heated. To work around this problem, repeat the steps described in the table, holding the knob
longer after turning on the burner.
CAUTION!
Ignition should be carried out without any pan or other object placed inside the oven.
When ignition is complete, it is possible to close the furnace door to allow preheating of the cavity:
although the furnace heating takes place quickly, it is advisable to wait a preheating period of about
15 minutes, after setting the desired temperature level as indicated in the next paragraph.
FLAME REGULATION
To set the desired cooking temperature, operate the control knob counter clockwise and more
precisely place the indicator placed on the knob in the control range between the minimum MIN
and maximum MAX mark The oven is limited to a maximum temperature of 200° C.
The flame delivery is regulated by the thermostat associated with the control knob: it is possible that
during operation there is a change in the length of the flame due to the automatic modulation of
the gas supply carried out by the thermostat.
CAUTION!
If the flame is unstable and uneven, check the correct positioning of the external
components of the burners and make sure there are no obstructions.
To Next Page
Loading...