Canberra 2016 - PC Software Installation

To Next Page

To Previous Page

D. PC Software Installation

To install the software for a Genie-2000 (Windows 95/NT) system, refer to the first

subsection below. To install the software for a Genie-PC (OS/2) system, refer to the

second subsection.

Installing the Genie-2000 Software

1. If you are installing this software as an upgrade, make sure that no

Genie-2000 software is running, including the VDM.

2. Put the disk labeled “Genie-2000 2016 Setup Software” in your floppy drive.

3. Open a DOS Prompt (command) window and type

x:\setup

where “x:” is the floppy drive designator.

4. To complete the installation, just follow the simple instructions you’ll see on

the screen.

Installing the Genie-PC Software

1. If you are installing this software as an upgrade, make sure no Genie-PC

software (including the VDM) is running.

2. Put the disk labeled “GENIE-PC AIM SFT Driver” into your floppy drive.

3. Open an OS/2 window session and, at the system prompt,y> type the

following commands:

cd 2016

setup

If you are using drive b:, make that your first command.

4. Follow the simple instructions provided by the software to complete the

installation.