EN 6 EN 7
•
WARNING: Accessible parts may become hot during use. Young
children should be kept away.
INSTALLATION WARNINGS
• The oven can be located high in a column or under a worktop.
• Before xing, you must ensure good ventilation in the oven space
to allow proper circulation of the fresh air required for cooling and
protecting the internal parts. Make the openings specied on the
illustrations according to the type of tting. Always x the oven to
the furniture with screws provided with the appliance.
• No additional operation/setting is required in order to operate the
appliance at the rated frequencies.
• The appliance must not be installed behind a decorative door in
order to avoid overheating.
• During installation the oven should be disconnected from the
mains to avoid overheating.
• If the assistance of the manufacturer is required to rectify faults
arising from incorrect installation, this assistance is not covered
by the guarantee. The installation instructions for professionally
qualied personnel must be followed.
• Incorrect installation may cause harm or injury to people, animals
or belongings. The manufacturer cannot be held responsible for
such harm or injury.
• Installation must be carried on by a qualied technician who must
know and respect the laws in force in the country of installation
and the manufacturer’s instruction.
• After unboxing the appliance, always check it is not damaged, in
case of issue contact the customer service before installing and do
not connect to the power supply.
• Remove the packaging material before operating the appliance.
• During installation do not use the oven door’s handle to lift and
move the oven.
• The installation furniture and the adjacent ones must with stand
temperatures of 95°C.
• It is recommended to wear protective gloves during installation to
avoid cut injuries.
• Do not install the product in open environments exposed to at-
SAFETY INFORMATION
mospheric agents.
• This appliance is designed to be used at altitude lower than 2000m.
ELECTRICAL WARNINGS
• The socket must be suitable for the load indicated on the tag and
must have ground contact connected and in operation. The earth
conductor is yellow-green in colour. This operation should be car-
ried out by a suitably qualied professional.
• Connection to the power source can be made by plug or by xed
wiring placing an omnipolar breaker, with contact separation
compliant to the requirements for overvoltage category III, be-
tween the appliance and the power source that can bear the max-
imum connected load and that is in line with current legislation.
• ln case of incompatibility between the socket and the appliance
plug, ask a qualied electrician to substitute the socket with an-
other suitable type. The plug and the socket must be conformed
to the current norms of the installation country.
• The yellow-green earth cable should not be interrupted by the
breaker. The socket or omnipolar breaker used for the connection
should be easily accessible when the appliance is installed.
• lf the supply cord is damaged, it must be replaced by the manu-
facturer, its service agent or similarly qualied persons in order to
avoid a hazard. For any repairs, refer only to the Customer Care
Department and request the use of original spare parts.
• Disconnect the appliance from the mains electricity supply before
carrying out any work or maintenance on it.
•
WARNING: ensure that the appliance is switched off before
replacing the bulb, to avoid the possibility of electric shocks.
• The oven must be switched off before removing the removable
parts. After cleaning, reassemble them according the instruc-
tions.
• The use of any electrical appliance implies the observance of some
fundamental rules:
– do not pull on the power cable to disconnect the appliance
from the power source;
– do not touch the appliance with wet or damp hands or feet;
– in general the use of adaptors, multiple sockets and extension
SAFETY INFORMATION
To Next Page
Loading...
