CT-2000 Instruction Manual
Unpack & Assemble
This section of the manual provides assistance in unpacking and assembling the CT-2000 Constant
Temperature Bath.
Unpack the CT-2000
The CANNON CT-2000 Constant Temperature Bath is shipped in several boxes containing the
following components:
• Bath housing, including the electronics drawer
• Motor and stirrer, including the impeller and mounting plate
• Glass bath jar
• Allen wrench
• Front glass panel pieces (2)
• Seven hole covers
• Jar gasket top and bottom
• Rubber thermometer holder
• Instruction manual
The bath unit housing is shipped completely assembled. However, the glass jar, the glass panels, and
the motor and stirrer must be installed. To install these components, some disassembly of the bath
unit housing is required. The tools required are a utility knife, Phillips screwdriver, and a 1/8" Allen
wrench which is included with the bath. The utility knife and Philips screwdriver must be supplied by
the user.
1. Remove all components from the shipping container(s).
2. Remove any and all packing materials (Styrofoam, etc.) from the components.
3. Verify reception of shipped materials by comparing equipment items with packing/parts list(s).
Report missing items to Cannon Instrument Company immediately.
To Next Page
Loading...
