3.1.12 Caution about Replacing Waste Ink Absorber
Please perform the following procedure to reset Waste Ink Counter whenever Waste Ink Absorber is replaced.
1. Enter the Service Mode, and then select [TEST MODE].
2. Press the [Start] button.
3. [TEST MODE [1]-[8]] is displayed.
4. Press [#] button.
5. [AMI MODE [1]-[*9]] is displayed.
6. Press [7] button.
7. [FACULTY [1]-[6] ] is displayed.
8. Press [6] button.
9. [LOST INK CHECK] is displayed.
10. Press the [Start] button.
11. [LOST INK CHECK [1]-[2]] is displayed.
12. Press [2] button.
13. [SET LOST CNT] is displayed.
14. Press the [Start/Copy] button. [LOST INK=0] is displayed on LCD. Press the numeric button to reset
the waste ink counter.
15. Press the [Start/Copy] button to have [TEST MODE [1]-[8]] displayed on LCD again.
1-20
To Next Page
Loading...
