Additional Information • 65
System Setup (Volume, Beep, etc.)
SYSTEM SETUP
[SPEAKER VOL.]: Adjust ( ) the volume of the playback.
[BEEP]: A beep will accompany some operations like turning on the camcorder, the self-
timer countdown, etc. It also serves as a warning beep under unusual conditions.
[POWER SAVE]: In order to save power when the camcorder is powered by a battery
pack, it will automatically shut off if left without any operation for 5 minutes. Approximately
30 seconds before the camcorder shuts off, the message “ AUTO POWER OFF” will
appear.
[ STANDBY OFF]: Select the length of time after which the camcorder will end the
standby mode and shut off automatically.
[FILE NOS.]: Select the image numbering method to be used when you insert a new
memory card.
Images are automatically assigned consecutive image numbers from 0101 to 9900, and
stored in folders containing up to 100 images. Folders are numbered from 101 to 998.
[ RESET]: Image numbers will restart from 101-0101 every time you insert a new
memory card.
[ CONTINUOUS]: Image numbers will continue from the number following that of the
last image recorded with the camcorder.
• If the memory card you insert already contains an image with a larger number, a new
image will be assigned a number one higher than that of the last image on the memory
card.
• We recommend using the [ CONTINUOUS] setting.
[TV TYPE]: In order to display the picture in full and in the correct aspect ratio, select the
setting according to the type of television to which you will connect the camcorder.
[ NORMAL TV]: TV sets with 4:3 aspect ratio.
[ WIDE TV]: TV sets with 16:9 aspect ratio.
[FIRMWARE]: You can verify the current version of the camcorder’s firmware. This menu
option is usually grayed out.
Menu item Setting options
CAMERA PLAY
[SPEAKER VOL.] – – z ––
[BEEP] [ HIGH VOLUME],
[ LOW VOLUME], [ OFF]
zzzz–
[POWER SAVE] [ON], [ OFF] zzzz–
[ STANDBY OFF] [ 10 min], [ 20 min],
[ 30 min]
zz –––
[FILE NOS.] [ RESET], [CONTINUOUS] – z –––
[TV TYPE] [ NORMAL TV], [ WIDE TV] zzzz–
[FIRMWARE] – – – – z –
COPY
Downloaded From VideoCamera-Manual.com Manuals
To Next Page
Loading...
