•
If paper is jammed in the back of the printer
Remove the jammed paper from the back of
the printer.
After removing the paper, make sure there are
no other scraps of paper in the printer.
3
Press the OK button.
Cut sheets cannot be pulled out from the front paper feed slot
Cut sheets cannot be pulled out from the front paper feed slot
Cause Corrective Action
You have loa-
ded paper other
than POP
board.
Push the cut sheet from the front side of the printer towards the back side. Once the edge of the cut sheet protrudes
from the back side of the printer, pull it out from the back side.
Roll paper cannot be inserted into the paper feed slot
Roll paper cannot be inserted into the paper feed slot
Cause Corrective Action
The roll paper is warped. Straighten out curls and reload the roll.
Paper is jammed by the paper feed slot. Remove the jammed paper.
(See "Clearing Jammed Roll Paper.") →P.103
(See "Clearing a Jammed Sheet, Fed Manually.") →P.106
After a roll was advanced, the paper was manually pulled out by force, clos-
ing the Paper Feed Slot.
Remove the roll and open the paper feed slot.
(See "Removing the Roll from the Printer.") →P.14
Cannot load sheets
Cannot load sheets
Cause Corrective Action
The paper source selection is incorrect. Press the Load button and select the paper source.
iPF6450
Cut sheets cannot be pulled out from the front paper feed slot
Basic Guide
Troubleshooting Problems Regarding Paper
109
To Next Page
Loading...
Need help?
General