Specifying the frame type using the printer Control Panel
1. On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2. Press the OK button.
The Set./Adj. Menu is displayed.
3. Press â–² or â–¼ to select Interface Setup, and then press the OK button.
4. Press â–² or â–¼ to select NetWare, and then press the OK button.
5. Press â–² or â–¼ to select NetWare, and then press the OK button.
6. Press â–² or â–¼ to select On, and then press the OK button.
The display reverts to the NetWare menu.
7. Press â–² or â–¼ to select Frame Type, and then press the OK button.
8. Press â–² or â–¼ to select the frame type to use, and then press the OK button.
The display reverts to the NetWare menu.
9. Press â–² or â–¼ to select Print Service, and then press the OK button.
10. Press â–² or â–¼ to select the desired print service, and then press the OK button.
The display reverts to the NetWare menu.
Network Setting
>
NetWare Settings
>
Specifying the Printer's Frame Type
iPF750
9
712
To Next Page
Loading...
Need help?
General
