6
3. ERROR DISPLAY
Errors are indicated by the LED, and warnings are displayed on the monitor of the computer connected
to the printer.
3-1. Operator Call Errors (Alarm LED Blinking in Orange)
Alarm LED
blinking in
orange
Error [Error code] Solution Remarks
No paper. (ASF) [1000] Set the paper in the ASF, and press the
Resume/Cancel button.
No CD / DVD tray. [1001]
*1
Set the CD / DVD tray, and press the
Resume/Cancel button.
No paper in the cassette.
[1003]
Set the paper in the cassette, and press
the Resume/Cancel button.
2 times
No CD / DVD. [1002]
*1
Set a CD or DVD in the CD / DVD tray
(which is ejected at error occurrence),
and insert the CD / DVD tray in the proper
position. Then, press the Resume/Cancel
button.
Paper jam. [1300] Error in paper feeding from the
ASF.
Paper jam in the rear guide.
[1303]
Error in the duplexing transport
unit.
Paper jam in the under
guide. [1304]
Remove the jammed paper, and press
the Resume/Cancel button.
Error in paper feeding from the
cassette.
3 times
Front door close error.
[1250]
Open the paper output tray. The error is indicated if the paper
output tray is closed at start of a
print job, or while a print job is
being performed.
No ink. [1600] Replace the empty ink tank(s), or press
the Resume/Cancel button.
Pressing the Resume/Cancel
button will exit the error without ink
tank replacement, however, ink
may run out during printing.
4 times
Ink tank not installed. [1660] Install the applicable ink tank(s) properly,
and confirm that the LED's of all the ink
tanks light red.
The print head is not
installed. [1401]
Print head temperature
sensor error. [1403]
Faulty EEPROM data of the
print head. [1405]
5 times
Print head hardware error.
[1682]
Install the print head properly.
To Next Page
Loading...
