What to do if my Canon All in One Printer shows a URL Scheme error (not https)?
If the Canon All in One Printer displays a 'URL Scheme error(not https)', it means the URL header of the registered server is not using 'https'. To resolve this, correct the server URL header to 'https' via: Service Mode > #E-RDS > RGW-ADDRESS.
Why is the communication test not performed on my Canon iR1024?
If your Canon All in One Printer suspends and the communication test isn't performed, it's likely because e-RDS is ON but was activated without completing the Communication test, possibly after a device reboot. To fix this, perform and complete the Communication test (COM-TEST).
What to do if Event Registration failed on Canon iR1024 All in One Printer?
If the Canon All in One Printer fails during event registration, it indicates a processing failure within the device. Try turning the device OFF and then ON again. If the problem persists, reinstall the device system software.
How to fix communication test failure on Canon iR1024 All in One Printer?
If the communication test fails on your Canon All in One Printer, you should check the firmware version and the network settings. Also, check the results of the communication test.
Why are no e-RDS settings items found in the Service Mode of my Canon iR1024 All in One Printer?
To address the issue of no e-RDS settings items being found in the Service Mode of your Canon All in One Printer, ensure that the firmware version is WLaa-60-xx or later. Also, verify that the network is up and running.
General| Print Technology | Laser |
|---|---|
| Max Paper Size | A4 |
| Scanner Type | Flatbed |
| Interface | USB 2.0 |
| Paper Output | 100 sheets |
| Print Speed | 24 ppm |
| Print Resolution | 600 x 600 dpi |
| Copy Speed | 24 cpm |
| Scan Resolution | 600 x 600 dpi |
| Supported OS | Windows, Mac |
| Paper Sizes | A4, A5, B5, Letter, Legal, Executive |
| Multiple Copy | Up to 99 copies |
| Paper Weight | 64 to 163 g/m² |
To Next Page
