dvanced Guide
>
Troubleshooting
> Print Head Holder Does Not Move to the Position for Replacing
Print Head Holder Does Not Move to the Position for Replacing
Check 1: Is the
Power
lamp off?
Check if the
Power lamp is lit blue.
The Print Head Holder will not move unless the power is on. If the Power
lamp is off, close the
Scanning Unit (Cover) and turn the machine on.
While the
Power
lamp is flashing blue, the machine is initializing. Wait until the
Power
lamp stops
flashing and remains lit blue, and then open the Scanning Unit (Cover) again.
Check 2: Is an error message displayed on the LCD?
Close the Scanning Unit (Cover), confirm the number of times the Alarm
lamp is flashing, take the
appropriate action to resolve the error, and then reopen it. For details on how to resolve the error,
see
n Error Message Is Displayed on the LCD
.
Check 3: Has the Scanning Unit (Cover) been left open for 10 minutes or
longer?
If the Scanning Unit (Cover) is left open for more than 10 minutes, the Print Head Holder moves to
the right to prevent the Print Head from drying out. Close and reopen the Scanning Unit (Cover) to
return the Print Head Holder to the center.
Check 4: Has the machine been printing continuously for a long
period?
Close the Scanning Unit (Cover), wait a while, then reopen it.
If the machine has been printing continuously for a long time, the Print Head Holder may not move to
the center since the Print Head may overheat.
Note
Opening the Scanning Unit (Cover) while printing moves the Print Head Holder to the right. Close
the Scanning Unit (Cover), and reopen it after printing finishes.
Page top
Page 813 of 947 pagesPrint Head Holder Does Not Move to the Position for Replacing
To Next Page
Loading...
Need help?
General
