Canon Omnera 500A - Portable Detector, Table; Set the Detector

Operator´s Manual
1000-095-071-EN Rev. 1.1 OMNERA®
2020-09-14 Page 139
4.12 Portable detector, table
Note!
This instruction applies only to a portable detector.
CAUTION!
Do not put any load on the detector tray. It might be damaged.
CAUTION!
Always supervise movements of the detector to avoid collision with peripherals.
Note!
If the System includes more than one detector, assure that the active detector is used.
4.12.1 Set the detector
1. Pull out the detector tray.
Fig. 4-39 Releasing the detector tray
Fig. 4-40 Pulling out the detector tray
Operating the System
Portable detector, table