100
If you select [Do Not Register], the camera angle will move to the home position the next time it is booted. If you have not
specified the home position, the camera angle will move to the factory default setting. For information on specifying the
home position, please refer to P. 118.
When [Digital PTZ Position] is set to [Do Not Register], you can perform pan, tilt, and zoom operations on the video display area using Area
Zoom (P. 58).
[Digital PTZ Position]
Register the current digital PTZ position as the initial setting.
If you select [Register], a yellow frame is shown in the video display area. Operate the frame to specify the Digital PTZ trim
position during startup.
The Digital PTZ trim frame (yellow) displayed during startup can be set to incremental sizes. The sizes that can be set are the same as the
Digital PTZ of the Viewer (P. 65).
Camera Settings
Sets the camera settings at camera start up.
[Simple Camera Settings]
Recommended settings for [Camera Settings] are displayed according to the selected type (The table below shows the
items and their differing recommended values). You can also change the recommended settings as required and click
[Apply].
Type Motion Priority
Depth Priority
Low Light Visibility
Data Size
Reduction
Standard Settings
Usage scenario
Reduces
vibrations for
moving subjects.
Focuses within a
wide range, from
near to far.
Brightens by
raising the
sensitivity for dark
subjects.
Reduces the data
size in low-light
conditions.
Cancels the
scenario settings
and restores the
factory default
settings.
[Exposure] Auto
Auto (Aperture-
priority AE)
Auto Auto Auto
[AGC Limit]66646
[Shutter Speed
Limit (Lower)]
1/1000 (sec.)
1/250 (sec.)
1/30 (sec.) 1/8 (sec.) 1/8 (sec.) 1/30 (sec.)
[Shutter Speed
Limit (Upper)]
1/16000 (sec.) 1/16000 (sec.) 1/16000 (sec.) 1/16000 (sec.) 1/16000 (sec.)
[Smart Shade
Control]
Disable Disable Disable Disable Disable
[Noise Reduction] Mild Standard Strong Strong Standard
[Sharpness]36333
[Color Saturation]44424
[Haze
Compensation]
Disable Disable Disable Disable Disable
S30 S31
S30 S31
S30 S31
To Next Page
Loading...
Need help?
General
