30 Preparations
NOTES
• The wireless controller may not work properly when the remote sensor
is situated under strong light sources or direct sunlight.
• If the wireless controller does not work, check that [Wireless
Remote Control] is not set to [ Off ]. Otherwise, replace the
battery.
Accessories
Fasten the grip belt.
Adjust the grip belt so that you can reach
the zoom lever with your index finger, and
the button with your thumb.
To remove the grip belt
1 Lift the padded handgrip's flap and detach the strap from the
Velcro pad.
2 Pull the strap to remove it first from the front bracket on the
camcorder, then to unthread it from the handgrip and finally to
remove it from the rear bracket on the camcorder.
START/STOP
To Next Page
Loading...
