3
59
English
58
English
Firmware Info [FWI]
This feature helps you to check and verify the firmware installed on the Smart Amp 5�1� Before doing a service request, please check and note the
indicated version numbers�
The listed items have the following meanings:
• WiFi [WIF]: The firmware version of the build-in WiFi module�
• Google Cast [GC]: The Chromecast build-in version�
• MCU Host [MCU]: The firmware version of the main control processor of the Amp 5�1 (like the OS on a computer)�
• STS Wireless [STS]: The firmware version of the wireless audio module�
• DSP Audio [DSP]: The firmware version of the digital sound and signal processor�
• OSD Fonts [OSD]: The version of the On-Screen display fonts and display indications�
To view the firmware information, do the following:
1
To enter the menu, press the "M" button�
2
Use the " " or " " button to navigate to the menu System Info [INF] and confirm with the "OK" button�
3
Select the menu item Firmware Info [FWI] and confirm with the "OK" button� All firmware versions will the be displayed as a list in case you
have have TV connected�
4
In case you do not have a TV connected to the Amp 5�1 you can select the specific firmware version by using the " " or " " button and press
the "OK" button to confirm� The information about the firmware version will then be shown as scroll text in the display� To exit the selected info
press the "M" button�
5
Repeat step 4 until you have all needed informations�
6
Exit the menu item by pressing the "M" button�
Note: After a shutdown (Smart Amp 5�1 disconnected from the mains) it takes up to 90 seconds until the firmware version for the
WiFi module [WIF] and the Google Cast [GC] version can be displayed�
Network Info [NWI]
This menu item is used to view all information about the network and related settings of the Smart Amp 5�1�
The listed items have the following meanings:
• IP Adress [IP]: The IP (internet protocol) adress of the WiFi module assigned by the network-router�
• MAC Adress [MAC]: The Media Access Control adress is a unique, unchangeable identification number of the WiFi module�
• Name [NAM]: The (network)name of the Amp 5�1 that has been set during the installation process� The default name is set as
Smart Amp 5�1�
• SSID [SSI]: The name of the connected WiFi network�
• WiFi Band [BAN]: The current frequency band of the WiFi module�
• STS Wireless [WCH]: The current frequency band of the wireless audio module�
To view the network information, do the following:
1
To enter the menu, press the "M" button�
2
Use the " " or " " button to navigate to the menu System Info [INF] and confirm with the "OK" button�
3
Select the menu item Firmware Info [FWI] and confirm with the "OK" button� All firmware versions will the be displayed as a list in case you
have have TV connected�
4
In case you do not have a TV connected to the Amp 5�1 you can select the specific firmware version by using the " " or " " button and press the
"OK" button
to confirm� The information about the firmware version will then be shown as scroll text in the display�
To exit the selected info press the "M" button�
5
Repeat step 4 until you have all needed informations�
6
Exit the menu item by pressing the "M" button�
Note: • The IP address and frequency band of the WiFi module (WiFi band) can only be displayed after the Smart Amp 5�1 is connected
to your network via WiFi or network cable� If the Amp 5�1 is connected via network cable, it is not possible to display the SSID�
To Next Page
Loading...
