3
105
English
8
If you do not want to assign a button to input BPD [HD1] you can select the next input by using the "+" resp. the "–" key.
Note:
When using the optionally available Canton Smart remote please use the " " button to select the next resp. the " " button for the
previous input.
9
If you do not press any button on the TV remote control within 15 seconds, the system returns to the IR Menu.
10
The BT input is the last entry in the list. After this input the system jumps back to the IR menu.
Note: Due to the variety of infrared codes it is not possible to guarantee that every IR remote control signal can be learned by the Connect
5.1. Signals from radio frequency (RF) remote controls cannot be learned, generally!
IR Clear [CLR]
Use this function to delete all IR codes stored on the Connect 5.1.
Note:
Deleting stored IR commands is only possible with the optionally available Canton Smart remote.
To delete IR commands please do the following:
1
To enter the menu, press and hold the input select key " " for at least 3 seconds
2
Use the "+" resp. the "–" key to select the menu item System Setup [SYS] and confirm with the "Play/Pause" button " ".
3
Use the "+" resp. the "–" key to select the menu item IR Menu [IRM] and confirm with the "Play/Pause" button " ".
4
Use the "+" resp. the "–" key to select the menu item IR Clear [CLR] and confirm with the "Play/Pause" button " ".
5
"Reset All" appears on the screen and [YES] appears on the display. Press the OK button on the Canton Smart remote to delete the
stored commands. The screen will display "Please Wait". The system will then return to the IR menu [IRM].
6
To cancel the operation press the input select key " " or select "No" [NO] by using the "+" or the "–" key and confirm with
"Play/Pause" button "
".
To Next Page
Loading...
Need help?
General
Weight and Dimensions
