DST (Distance)
Adjusting the distance between the seat position and the speakers is necessary to get the perfect spatial impression
in multi-channel recordings� The distance can be adjusted in 10 cm steps from 0�0 m to 9�9 m�
If the distance is higher than 9�9 m, set the difference values of the individual distances in relation to 3 m�
Decisive for the calculation of the spatial effect are the differences between the channels, not the absolute distance values�
1
Select the SPS menu as described in the chapter SPS (Speaker Setup) and select the DST function using the
navigation keys “
” and “ ”, then press OK�
2
Use the navigation keys “ ” and “ ” to select the desired speaker� The range of the selected speaker can be
changed separately using the “+/–” keys within a range of 0�0 m to 9�9 m�
Note: This menu only lists the physically available speakers�
VOI (Voice, Enhancement of speech intelligibility)
Use the “Voice” function to boost speech intelligibility in both stereo and surround mode�
This allows you to better understand dialogues (speech) in films with loud effects, for example�
1
Select the SPS menu as described in the chapter SPS (Speaker Setup), then use the navigation keys “ ” and “ ” the VOI function to select�
2
Use the “+/–” keys to switch the “Voice” function on or off (ON or OFF)�
To Next Page
Loading...