Menu Settings
EQ (Equalizer)
The Equalizer menu allows you to select three different equalizers for the FLR (front left and right), CE (Centre), SLR (surround left and right)
and SUB (subwoofer) speakers to match the room conditions� Only physically available speakers are displayed� To change the equalizer
settings do the following:
1
Select the SPS menu as described in the chapter SPS (Speaker Setup) and select the EQ function using the navigation
keys “
” and “ ”, then press OK�
2
Select the desired speakers using the navigation keys “ ” and “ ” and change the EQ using the “+/–” keys�
• EQ1 for free installation (factory setting)�
• EQ2 for installation on a rear or side panel�
• EQ3 for installation in a corner of a room�
DRC (Dynamic Range Control)
“Dynamic Range Control” is a setting option from Dolby Laboratories� When the function is activated, the
dynamic range can be automatically reduced when data streams are encoded, which reduces volume differences�
Low volume is enhanced and high volume is attenuated�
1
Select the SPS menu as described in the SPS chapter (Speaker Setup) and use the navigation buttons “ ” and “ ” to select DRC�
2
With the “+/–” buttons, you can turn the
DRC
on or off�
SYS (System Setup, System Settings)
Press the “M” button until SPS is displayed� Press the “
” button now, until SYS is displayed�
Press the “OK” button and use the navigation buttons “
” and “ ” to obtain the desired function�
To Next Page
Loading...