Problem Possible cause Solution
The device uninten-
tionally changes the
input�
1� This can happen if the SEL function is set to
on AUT and the currently selected input (Line,
Balanced, USB) has a long break in the title
(>10 seconds) and a signal is present at ano-
ther input or the source device is turned on at
the optical and coaxial input�
1� Make sure that no signal is present at any other input
during playback at the Line, Balanced and USB inputs or
that a device is switched on at the optical and coaxial
digital input�
2� This can happen when your mobile device
issues system sounds, such as typing on the
keyboard�
2� Disable these system sounds on your end device�
2�2 Set the SEL resp� BTS function to MAN�
The speakers do not
turn on together�
1� The speakers are not coupled together� 1� Pair all slave speakers according to chapter
WSP (
Wireless Speaker Pairing, see Page 78)
�
2� The parameter STB is set to ECO� 2� If the parameter STB is set to ECO, each speaker must be
switched on separately with the remote control� If you
want to switch all speakers on together, set the parameter
to NSB, MAN or AUT�
To Next Page
Loading...