Positioning the speakers
CANTON-SPEAKERS IN A STEREO SET UP
The "stereo triangle" is a good rule of guidance for optimum positioning of your new Canton speakers (Fig. 1).
This means that best performance is usually obtained when the two speakers and your favourite listening posi-
tion lie at the corners of an equilateral triangle.
If you use Canton compact speakers the optimum vertical position is given at approximately the level of your ears
when listening. You can place the speakers on a shelf or alternatively use speaker stands from the Canton LS-
series which are available as accessories.
For decoupling the speakers from the floor most Canton speakers are provided with self-adhesive rubber pucks.
The damping pucks can be stuck underneath the speakers after removing the protecting film.
If there are tapped holes provided in the bottom of your Canton speaker use them for attaching the metal
spikes.
Most of the Canton compact speakers can be mounted to the wall. Therefore use a Cantomount wallbracket
which is not allways included.
If you need LS-Loudspeakerstands or Cantomount wallbrackets please contact your next authorised Canton
dealer.
To Next Page
Loading...
