Why does my iPod cannot be operated via remote control and shows “no iPod” on Canton Speakers?
If your iPod cannot be operated via remote control and shows “no iPod”, there may be a contact problem. Remove any protective covers from the iPod/iPhone and plug the device into the dock connector again.
What to do if Canton Speakers musikbox M has too much bass?
If your musikbox M has too much bass, check the bass level in the menu “Sound control” and ensure it is not set to a value of > 0 dB. If you are listening with high volume and have “Bass expand” activated, set “Bass expand” to “Off”. If using an external subwoofer, ensure it is correctly set with less level. Finally, consider repositioning the system, possibly farther away from the wall.
What to do if Canton Speakers musikbox M sounds “dull” (not enough treble)?
If the musikbox M sounds “dull”, and lacks treble, it could be due to the acoustic space being strongly dampened or the treble sound control being lowered. Try lifting the treble in the menu “Treble”.
What to do if Canton musicbox M Speakers musikbox M sounds “sharp”/ “aggressive” (too much treble)?
If the musikbox M sounds “sharp” or “aggressive” with too much treble, it could be because the acoustic space is acoustically “hard” (little dampened). Adjust the treble in the menu “Treble”.
Why is there no playback via Bluetooth on Canton musicbox M?
If there is no Bluetooth playback, ensure there is a connection between the musicbox M and your mobile device, and connect your mobile device. If the mobile device is connected but playback is not occurring, try reconnecting it. Other possible reasons: you are out of range; set the volume at the mobile end device to the maximum possible value; ensure that interference sources like a WLAN router or laptop are not set up in direct proximity of the musicbox M; concurrent operation of WLAN and Bluetooth from a mobile end device is not possible without interferences in most cases.
What to do if there is no sound playback on Canton Speakers musicbox M?
If there is no sound, ensure the correct sound format is selected on your source device, as “DTS” or “Dolby Digital” coded output formats cannot be played back. Also, verify that the digital output at the source device is enabled. Check the cable connection between the source device and the musicbox M, replacing it if necessary. Ensure the correct input is selected on the musicbox M, and that the device is not muted by pushing the mute button until the volume value is displayed.
What to do if Canton musicbox M Speakers display is dark?
If the display is dark, the function DISP may be set to “Off”. Select another value other than “Off”.
What to do if the sound played back is too low on Canton Speakers musicbox M?
If the sound playback is too low, the volume of the musicbox M might be set too low. Increase the volume using the “Volume” button.
Why does Canton Speakers musicbox M not react to remote control?
If the musicbox M does not respond to the remote control, the battery may be empty. Replace the battery, ensuring you observe the correct polarity during insertion.
Why is a set radio transmitter no longer present after switching Canton musicbox M Speakers off and on?
If a set radio transmitter is no longer present after switching the unit off and on again, it is likely that the transmitter was not stored on the memory slot. Repeat the storage process.
General| Type | Portable Bluetooth Speaker |
|---|---|
| Battery Life | Up to 10 hours |
| Principle | 2-way bass reflex |
| Connectivity | Bluetooth, AUX-In |
| Color | Black, White |
Visual guidance on safe handling, placement, and operation.
Detailed instructions and precautions for safe device operation.
Specific guidance on safe handling of power cords and connections.
How to connect analogue and digital audio sources.
Steps for connecting and playing audio via Bluetooth.
Instructions for connecting and playing Apple devices.
How to connect antenna, tune, and save radio stations.
Solutions for frequent operational problems and errors.
To Next Page
