Instruction manual C843I
Please keep this instruction manual for future reference
22
BEFORE INSTALLING THE HOB
- The induction hob must be installed by qualified personnel or Caple technicians.
Please never conduct the installation yourself.
- Check the work surface is square and level, and no structural members interfere
with space requirements.
- Check the work surface is made of a heat-resistant material.
- If the hob is installed above an oven, the oven has a built-in cooling fan.
- The installation will comply with all clearance requirements and applicable
standards and regulations.
- Ensure a suitable isolating switch providing full disconnection from the mains
power supply is incorporated in the permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations.
- The isolating switch must be of an approved type and provide a 3mm air gap
contact separation in all poles (or in all active [phase] conductors if the local
wiring rules allow for this variation of the requirements).
- The isolating switch will be easily accessible to the customer once the hob is
installed.
- You consult local building authorities and by-laws if in doubt regarding installation.
- You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the
wall surfaces
AFTER INSTALLING THE HOB
- Ensure the power supply cable is not accessible through cupboard doors or
drawers.
- Ensure there is adequate flow of fresh air from outside the cabinetry to the base of
the hob.
- If the hob is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the hob.
- The isolating switch must be easily accessible by the customer.
BEFORE LOCATING THE FIXING BRACKETS
- The unit should be placed on a stable, smooth surface (use the packaging).
Do not apply force onto the controls protruding from the hob.
C843i_Induction hob Instruction manual.indd 22 31/05/2018 16:45
To Next Page
Loading...
