Instruction manual C843I
Please keep this instruction manual for future reference
27
Problem Possible causes What to do
Pans do not
become hot and
appears in the
display.
The induction hob cannot detect
the pan because it is not suitable
for induction cooking. The
induction hob cannot detect the
pan because it is too small for
the cooking zone or not properly
centred on it.
Use cookware suitable for
induction cooking. See section
‘Choosing the right cookware’.
Centre the pan and make sure
that its base matches the size of
the cooking zone.
The induction hob
or a cooking zone
has turned itself off
unexpectedly, a tone
sounds and an error
code is displayed
(typically alternating
with one or two
digits in the cooking
timer display).
Technical fault. Please note down the error letters
and numbers, switch the power to
the induction hob off at the wall,
and contact Caple service.
FAILURE DISPLAY AND ERROR CODES
If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding error codes:
Problem Possible causes What to do
F3-F8 Temperature sensor
failure.
Please contact Caple service
F9-FE Temperature sensor of the
IGBT failure.
Please contact Caple service
E1/E2 Abnormal supply voltage Please inspect whether power
supply is normal. Power on after
the power supply is normal.
E3/E4 Abnormal supply voltage Please inspect the pot.
E5/E6 Bad induction hob heat
radiation
Please restart after the induction
hob cools down.
The above are the judgment and inspection of common failures. Please do not
disassemble the unit by yourself to avoid any dangers and damages to the
induction hob.
C843i_Induction hob Instruction manual.indd 27 31/05/2018 16:45
To Next Page
Loading...
