Caple CM465SS - Page 17

17
Please keep this instruction manual for future reference Instruction manual CM465 / CM465SS / CM465GM
EN 15
USE
3. Lift the central lid, place one measure of preground coffee in the
funnel push the appliance back and proceed as described in the
section “Making coffee using coffee beans”. You can make just one
coffee at a time by pressing the ‘One cup deliver’ touch key (10).
4. After using the machine with pre-ground coffee, to go back to
making coffee using beans, deactivate the pre-ground coffee
function by pressing the ‘Coffee strength’ touch key (6).
Notes
• Never introduce pre-ground coffee when the machine is off as it
could spread through the inside of the appliance.
• Never add more than 1 measure, otherwise the appliance will not
make the coffee.
• Use the measure provided only.
• Introduce only pre-ground coffee for espresso coffee machines into
the funnel.
• If more than one measure of pre-ground coffee is used and the
funnel clogs, push the coffee down with a knife then remove and
clean the brewing unit and machine as described in the “Cleaning
the brewing unit” section.
Preparing hot water
Hot water can be used to warm up cups and to make hot drinks, such
as tea or packet soups.
Warning! Escaping hot water can lead to scalds! Only activate the
hot water nozzle when there is a receptacle underneath it.
1. Put the hot water nozzle in place.
2. Place a container underneath the hot water nozzle.
3. Press the ‘Hot water’ touch key (13).
The display shows “HOT WATER PRESS OK”.
4. Press the touch key ‘OK’ (9).
Hot water is dispensed; the display shows “HOT WATER”.
Once the programmed amount of hot water is dispensed,
dispensing stops automatically.
For a few seconds the display shows “PLEASE WAIT”. After that the
appliance is ready to make coffee again and the last selected coffee
setting appears on the display.
EN 15
USE
3. Lift the central lid, place one measure of preground coffee in the
funnel push the appliance back and proceed as described in the
section “Making coffee using coffee beans”. You can make just one
coffee at a time by pressing the ‘One cup deliver’ touch key (10).
4. After using the machine with pre-ground coffee, to go back to
making coffee using beans, deactivate the pre-ground coffee
function by pressing the ‘Coffee strength’ touch key (6).
Notes
• Never introduce pre-ground coffee when the machine is off as it
could spread through the inside of the appliance.
• Never add more than 1 measure, otherwise the appliance will not
make the coffee.
• Use the measure provided only.
• Introduce only pre-ground coffee for espresso coffee machines into
the funnel.
• If more than one measure of pre-ground coffee is used and the
funnel clogs, push the coffee down with a knife then remove and
clean the brewing unit and machine as described in the “Cleaning
the brewing unit” section.
Preparing hot water
Hot water can be used to warm up cups and to make hot drinks, such
as tea or packet soups.
Warning! Escaping hot water can lead to scalds! Only activate the
hot water nozzle when there is a receptacle underneath it.
1. Put the hot water nozzle in place.
2. Place a container underneath the hot water nozzle.
3. Press the ‘Hot water’ touch key (13).
The display shows “HOT WATER PRESS OK”.
4. Press the touch key ‘OK’ (9).
Hot water is dispensed; the display shows “HOT WATER”.
Once the programmed amount of hot water is dispensed,
dispensing stops automatically.
For a few seconds the display shows “PLEASE WAIT”. After that the
appliance is ready to make coffee again and the last selected coffee
setting appears on the display.
NOTES:
1. Never introduce pre-ground coffee when the machine is off as it could
spread through the inside of the appliance.
2. Never add more than 1 measure, otherwise the appliance will not
make the coffee.
3. Use the measure provided only.
4. Introduce only pre-ground coffee for espresso coffee machines into the
funnel.
5. If more than one measure of pre-ground coffee is used and the funnel
clogs, push the coffee down with a knife then remove and clean the
brewing unit and machine as described in the “Cleaning the brewing
unit” section.
PREPARING HOT WATER
Hot water can be used to warm up cups and to make hot drinks, such as
tea or packet soups.
WARNING:
Escaping hot water can lead to scalds. Only activate the hot water nozzle
when there is a receptacle underneath it.
1. Put the hot water nozzle in place.
2. Place a container underneath the hot water nozzle.
3. Press the ‘Hot water’ touch key (13). The display shows “HOT WATER
PRESS OK”.
4. Press the touch key ‘OK’ (9).
Hot water is dispensed; the display shows “HOT WATER”.
Once the programmed amount of hot water is dispensed, dispensing
stops automatically.
For a few seconds the display shows “PLEASE WAIT”. After that the
appliance is ready to make coffee again and the last selected coffee
setting appears on the display.