Instruction manual CM465 / CM465SS / CM465GM40 Please keep this instruction manual for future reference
INSTALLATION INSTRUCTIONS
WARNINGS:
› After removing the packaging, make sure the product is complete and undamaged. If in
doubt, do not use the appliance and contact your retailer.
› Installation must be carried out by qualified personnel and in compliance with current
regulations.
› Packing elements (plastic bags, polystyrene etc.) must not be left within reach of children as
they may represent a hazard.
› Never install the appliance in environments where the temperature may reach 0°C or lower
(the appliance may be damaged if the water freezes).
› Make sure the mains voltage corresponds to the voltage indicated on the appliance rating
plate. Connect the appliance to an efficiently earthed socket with a minimum current rating
of 10A.
The manufacturer may not be considered liable for possible incidents caused by the failure
to adequately earth the mains.
› Make sure the socket used is freely accessible at all times, enabling the appliance to be
unplugged when necessary.
› Never touch the plug with damp hands.
› Never pull the power cable as you could damage it.
› This appliance can be installed over a built-in oven if the latter is fitted with a cooling fan at
the rear (maximum power: 3KW).
› Do not use multiple plug adapters or extension leads.
› The power cable on this appliance must not be replaced by the user as this operation
requires the use of special tools. If the cable is damaged or requires replacing, contact an
authorised service centre only to avoid all risks.
› You should personalise water hardness as soon as possible following the instructions.
To Next Page
Loading...
