Caple CR700 - Timing

Instruction manual CR700 / CR750
Please keep this instruction manual for future reference
15
TIMING
- As a result of the new EU65 “Energy label” and EU66 “ Ecodesign” regulations
issued by the European Commission, which came into force as from January 1st,
2015 , our products have been adapted to comply with these new requirements.
All of the models complying with the energy label requirements, are equipped
with new electronics including a timer device for extraction speeds control, when
the air capacity exceeds 650m³/h. Internal motor models, with maximum air
capacity higher than 650m³/h, are equipped with a timer device that automatically
switches the extraction speed from 4th to 3rd speed, after 5 minutes operation
- External motor models are equipped with remote motors that , as for internal
motor versions, include a timer device that switches down the extraction speed
when it exceeds 650 m³/h. (See External Motors Instructions ). Remote motors,
whose air capacity exceeds 650m³/h at both 4th and 3rd speed, will have the
following by default timer control functions:
- The extraction speed is automatically switched from 4th to 2nd speed, after 6
minutes operation. If the appliance is working at 3rd speed, it is automatically
switched to 2nd speed, after 7 minutes operation. Operation speeds can also be
changed during operation. The energy consumption of the appliance in standby
mode is lower than 0.5W.
CR700_CR750_Instruction manual.indd 15 04/04/2018 14:08