Instruction manual DD810BK
34
Please keep this instruction manual for future reference
FAN TIMER:
The fan timer is used after cooking to completely eliminate cooking odours.
In addition, the filters are dried in the fan timer.
SETTING THE FAN TIMER:
1. Select the fan indication.
2. Then use the Plus key
OPERATING THE HOB
The hob is operated with touch control sensor keys. The sensor keys are operated as follows:
Lightly touch a symbol on the surface of the ceramic glass plate. A buzzer will indicate when the
controls have been operated correctly.
The touch control sensor key will then be indicated as “key”.
PERMANENT PAN RECOGNIT ION
A cooking setting can only be switched on via the slider (touch control) after a
pan has been detected on the hob and the power display shows 0.
ON/OFF KEY: ( 6 ) COOKING ZONES LEFT OR RIGHT
This key is used to switch the left or right hob on and off.
POWER BOOST IN THE TOUCH CONTROL: (7)
The power boost setting makes additional power available for induction cooking zones.
S T O P / PA USE KEY: ( 8 )
The STOP/PAUSE function can be used to briefly stop the cooking process.
( 8 )
RECALL FUNCTION:
(Recovery function)
The most recent setting can be recovered if the hob is switched off unintentionally.
C H I L D SAFETY LOCK KEY: ( 9 )
The lock key can be used to lock all of the keys.
KEEP WARM KEY: (10 )
To keep warm.
GRILL KEY: (11)
Grill function with a griddle plate for induction.
MINUS /PLUS KE Y: (1 2 )
These keys are used to set the timer and the automatic switch-off function of the
cooking zones as well as the automatic delay stop of the fan.
or the Minus key
OPERATING THE HOB
The hob is operated with touch control sensor keys. The sensor keys are operated as follows:
Lightly touch a symbol on the surface of the ceramic glass plate. A buzzer will indicate when the
controls have been operated correctly.
The touch control sensor key will then be indicated as “key”.
PERMANENT PAN RECOGNIT ION
A cooking setting can only be switched on via the slider (touch control) after a
pan has been detected on the hob and the power display shows 0.
ON/OFF KEY: ( 6 ) COOKING ZONES LEFT OR RIGHT
This key is used to switch the left or right hob on and off.
POWER BOOST IN THE TOUCH CONTROL: (7)
The power boost setting makes additional power available for induction cooking zones.
S T O P / PA USE KEY: ( 8 )
The STOP/PAUSE function can be used to briefly stop the cooking process.
( 8 )
RECALL FUNCTION:
(Recovery function)
The most recent setting can be recovered if the hob is switched off unintentionally.
C H I L D SAFETY LOCK KEY: ( 9 )
The lock key can be used to lock all of the keys.
KEEP WARM KEY: (10 )
To keep warm.
GRILL KEY: (11)
Grill function with a griddle plate for induction.
MINUS /PLUS KE Y: (1 2 )
These keys are used to set the timer and the automatic switch-off function of the
cooking zones as well as the automatic delay stop of the fan.
of
the timer to set the required time for the fan time lag.
Left position: Hours
Centre position: Every 10 minutes
Right position: Every minute
3. After a few seconds, your selection will be assumed and
the procedure will have commenced. The timer
symbol
POWER SETTING DISPLAY: (15 )
The power setting display shows the power setting which has been selected, or:
Residual heat
Power boost function
Pan recognition
Automatic boost function
Stop/Pause function
Child Safety Lock
Bridging function
Grill function
Keep-warm function
FAN INDICATOR (16)
The power setting indicator shows the power setting which has been selected, or;
Automatic function
Replace the carbon filter
SYMBOLS (14 )
Timer function, automatic switch-off device.
of the fan lights up.
4. The fan will be switched off when the time has lapsed.
If a cooking zone is switched on, the timer does not run until the cooking zone has been switched
off. If the hob is switched off using the ON/OFF key during fan after run-time, the timer runs down
to a low fan level.
odours.
1. Select the fan indication.
2. Then use the Plus key or the Minus key of the
timer to set the required time for the fan time lag.
Left position: Hours
Centre position: Every 10 minutes
Right position: Every minute
3. After a few seconds, your selection will be assumed
and the procedure will have commenced.
The timer symbol of the fan lights up.
4. The fan will be switched off when the time has lapsed.
AUTOMATIC FUNCTION:
1. To select Automatic mode, press and hold the
fan display (as a key) until 'A' for automatic
mode is shown in the display. The standby dot
will light up.
2. Then select one or more cooking zones and set a
power level.
3. The fan level is now automatically controlled
according to the set power levels.
Press for a longer time
The automatic mode operates slightly delayed
and gradually according to the set power levels.
You can switch back to manual mode at any time
by holding down the fan display or selecting the
fan display and pressing the touch control.
FAN TIMER:
The fan timer is used after cooking to completely eliminate cooking
In addition, the filters are dried in the fan timer.
S E T T ING THE FAN TIMER:
If a cooking zone is switched on, the timer does not run until the cooking zone has been switched
off. If the hob is switched off using the ON/OFF key during fan after run-time, the timer runs down
to a low fan level.
To Next Page
Loading...
