Caple PYR600 - Page 11

11Instruction manual PYR600Please keep this instruction manual for future reference
The cooker hood can be installed with top or rear ventilation. See ‘Rear Ducted Version’ section
before proceeding with the following installation instructions.
Using the template (Fig.3A), drill the holes to
install the hood onto the wall.
The cooker hood should be placed at a minimum
distance of 65-76cm above the hob. It is the
manufacturer of the hob who determines the
clearance required and the clearance quoted by
the hob manufacturer must be followed. In the
absence of any instructions supplied with a gas
hob the minimum distance between the hob and
the hood must be at least 760mm.
Fix the hood to the wall using the dowels and
screws supplied (Fig.4).
Open the front panel by lifting the lower section
upwards (Fig.5) and remove the grease lter but
pushing the lever down (Fig.6).
The cooker hood can be installed with top or rear ventilation. See 'Rear Ducted Version'
section before proceeding with the following installation instructions.
Using the template (Fig.3A), drill the
holes to install the hood onto the
wall.
The cooker hood should be placed at
a minimum distance of 65-76cm
abo
of the hob who determines the
clearance required and the clearance
quoted by the hob manufacturer must
be followed. In the absence of any
instructions supplied with a gas hob
the minimum distance between the
and the hood must be at least hob
760mm.
Fix the hood to the wall using the
dowels and screws supplied (Fig.4).
Open the front panel by lifting the
lower section upwards (Fig.5) and
remove the grease filter but pushing
the lever down (Fig.6).
Fig.5
Fig.6
ve the hob. It is the manufacturer
Fig.3
Fig.4
The cooker hood can be installed with top or rear ventilation. See 'Rear Ducted Version'
section before proceeding with the following installation instructions.
Using the template (Fig.3A), drill the
holes to install the hood onto the
wall.
The cooker hood should be placed at
a minimum distance of 65-76cm
abo
of the hob who determines the
clearance required and the clearance
quoted by the hob manufacturer must
be followed. In the absence of any
instructions supplied with a gas hob
the minimum distance between the
and the hood must be at least hob
760mm.
Fix the hood to the wall using the
dowels and screws supplied (Fig.4).
Open the front panel by lifting the
lower section upwards (Fig.5) and
remove the grease filter but pushing
the lever down (Fig.6).
Fig.5
Fig.6
ve the hob. It is the manufacturer
Fig.3
Fig.4