EasyManua.ls Logo

Caple PYR600 - Page 18

Caple PYR600
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 Instruction manual PYR600 Please keep this instruction manual for future reference
CLEANING AND MAINTENANCE
Accurate maintenance guarantees good functioning and long lasting performance.
Particular care must be made when handling the grease lter panel. It can be removed
by pushing its handle toward the back-side of the cooker hood and turning the lter
downwards so to unfasten it from its slot (Fig.4). To insert the lter just perform the
opposite operation.
After 30 hours of use, the control panel will signal the saturation of the grease lter by
illuminating all the buttons. Press the timer button
After 30 hours of use, the control panel will signal the saturation of the grease filter by illuminating all the
buttons. Press the timer button to reset.
The grease filter needs cleaning regularly by hand or in the dishwasher, at least every two months or more
depending on use.
NOTE:
If washing the grease filter in the dishwasher, wash separately to prevent food particles becoming trapped in the
filter mesh.
to reset.
The grease lter needs cleaning regularly by hand or in the dishwasher, at least every two
months or more depending on use.
NOTE:
If washing the grease lter in the dishwasher, wash separately to prevent food particles
becoming trapped in the lter mesh.
When the appliance is used in recirculating mode, the active charcoal lter (Fig.7) needs to
be periodically replaced. The charcoal lter can be removed by removing the grease lter
rst (Fig.3), and by pulling its special plastic tongue until it is unfastened from its slot.
Reinsert the charcoal lter by performing the opposite operation.
The active charcoal lter will need replacing depending on the use, but at least every six
months. To purchase replacement charcoal lters CAP47CF please visit
www.caple.co.uk.
To clean the appliance itself, tepid water and neutral detergent are recommended, while
abrasive products should be avoided.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualied person in order to avoid a hazard.

Related product manuals