Instruction manual TSCH601 TSCH901 15
Please keep this instruction manual for future reference
INSTALLING THE CHARCOAL FILTER (CAP60CF)
If you are not externally venting this extractor, you will require the CAP60CF recirculating filters to
use this extractor in recirculation mode (not included). To install these, firstly pull the retractable
front panel out to expose both aluminium grease filters. Remove these grease filters by pressing
the release button and pulling downwards as shown below.
Fit the charcoal filter onto the side of the motor and turn it in a clockwise direction to lock into
place. Repeat the same on the other side.
Scan the QR Code to access the ‘How To’ video.
NOTE:
Make sure the filter is securely locked. Otherwise, it may loosen and be dangerous.
When using a charcoal filter, the extraction power may be slightly reduced.
We recommend replacing these filters
every 6 months. Replacement filters (CAP60CF)
can be purchased directly
from www.caple.co.uk
9
(CAP61CF)
We recommend replacing these filters every 6 months. Replacement
filters (CAP61CF) can be purchased directly from www.caple.co.uk
9
(CAP61CF)
We recommend replacing these filters every 6 months. Replacement
filters (CAP61CF) can be purchased directly from www.caple.co.uk
9
(CAP61CF)
We recommend replacing these filters every 6 months. Replacement
filters (CAP61CF) can be purchased directly from www.caple.co.uk
9
(CAP61CF)
We recommend replacing these filters every 6 months. Replacement
filters (CAP61CF) can be purchased directly from www.caple.co.uk