8200-M129-O1 Rev D 205 Installation & Technical 50
SETUP AND CALIBRATION, CONT.
CrLF= (Carriage Return Line Feed) - Data Format Termination
Data transmitted from the serial I/O port can be terminated with a single carriage return and
either no line feed or a single line feed command. Press the TARE/ENTER key to view the
current setting. A YES on the display means the data will be terminated with a carriage return
AND a line feed while a no on the display means the data will be terminated with a single
carriage return only.
If the setting displayed is acceptable, press the TARE/ENTER key again to save it. Otherwise,
use the /UP ARROW key to toggle to a new setting and then press the TARE/ENTER key to
save it.
EoP= (End-Of-Print Line Feeds)
At the end of a data transmission to a printer, the indicator can transmit a pre-selected number
of line feed commands to space the paper in the printer to the desired position for withdrawal
or for the next print.
Press the TARE/ENTER key to view the current setting. If the displayed value is acceptable,
press the TARE/ENTER key to save it. Otherwise, use the /UP ARROW and UNITS/LEFT
ARROW keys to enter the new the number of End-Of-Print linefeeds and then press the
TARE/ENTER key to save the new setting. Allowable values are: 0 through 99.
To Next Page
Loading...
