Page 5
Price Look Up (PLU)
PLU Programming
Programming PLU without a Tare Weight
1. Press the PLU PGM key
2. Press the PLU key (PLU1 – PLU14) or enter the PLU number (15-99) to programmed.
3. Press ENTER
4. Enter the UNIT PRICE and press ENTER twice.
Programming PLU with a Tare Weight
1. Press the PLU PGM key
2. Press the PLU key (PLU1 – PLU14) or enter the PLU number (15-99) to programmed.
3. Press ENTER
4. Enter the UNIT PRICE and press ENTER
5. Enter the known Tare weight or place the empty container on the scale and press
ENTER.
PLU Operation
1. Press the key for the desired PLU (PLU1-PLU14 key or PLU key then number 15-99)
2. The PLU Unit Price will be displayed.
3. If a Tare weight is programmed for the selected PLU, the Weight displayed will be
negative and the NET annunciator illuminated.
4. Place the commodity on the scale. Be sure to use the proper container if a Tare weight
is programmed.
5. The Total Price will be displayed.
6. Remove the commodity, the scale will exit the PLU and return to zero weight.
Pre-Pack Operation with PLU
For repetitive price-computing of commodities with the same unit price.
1. Select the desired PLU as above.
2. Press the PRE-PACK key. The PRE-PACK annunciator will illuminate.
3. Place commodities on scale and proceed with operation.
4. Repeat until all commodities have been weighed.
5. When the pre-packing operation is ended, press the CLEAR key to turn off PRE-PACK
mode and exit PLU.
To Next Page
Loading...
Need help?
General