7
ERROR AND FAIL MESSAGES
FAIL A This message indicates a bad electrical component
requiring technical service.
UnStb This message occurs when the infant platform is
persistently unstable upon turning on scale.
LOD This condition occurs when turning on scale without the
infant tray on the scale.
UnLOD This message appears when turning on scale with
some weight on the infant tray. Remove weight
-OL- Indicates scale capacity has been exceeded.
-Lo- Indicates gross weight is less than 0.
BEFORE YOU CALL FOR SERVICE
Customer satisfaction is our prime objective. If, however, any problems occur
in connection with the operation of this scale, please check the following
points before calling for service:
1. Is the power cord fully inserted into the wall receptacle?
2. Is the power switch turned on?
3. Is the wall receptacle receiving proper AC power?
4. Check the circuit breaker.
5. Has there been a power failure of any kind?
6. Has proper operation procedure been followed?
If you have any problems, DO NOT TRY TO REPAIR THE SCALE
YOURSELF! Unplug the power cord and contact your Detecto dealer.
To Next Page
Loading...
Need help?
General
