5. TROUBLESHOOTING
5.1 SOFT RESET
If your PACKTALK SLIM stops responding, reset it in one of these ways:
● Turning it off and then on again (see Getting Started on page 5).
● Using the supplied USB cable, connect your unit to the computer or wall charger for 30 seconds.
5.2 RESET PAIRING
This option deletes all paired units and devices.
To reset pairing:
1. Confirm your unit is in Standby Bluetooth intercom mode (LED flashes blue slowly).
If your unit is not in Bluetooth intercom mode, tap and . For more information see, Switching
between Intercom modes on page 20.
2. While in standby mode, press for 5 seconds.
3. When the LED flashes red, press and for 2 seconds.
The LED flashes purple 5 times slowly, confirming that pairing has been reset.
5.3 RESET TO FACTORY SETTINGS
This option deletes all paired units, devices and all configuration settings.
To perform a factory reset through the unit:
1. Check that your PACKTALK SLIM is in Standby (see PACKTALK SLIM LEDIndications on page 27).
2. Simultaneously press + + for 5 seconds.
5.4 FAQ
Additional answers to common problems can be found at www.cardosystems.com/support/packtalk-slim/.
21
To Next Page
Loading...
Need help?
General
