AUDIO TONES
With the exception of the actions below, all other actions are followed
by a single tone to confirm that the headset has accepted the command.
Action Tone
Enable/Disable Always On One tone = Always On intercom
intercom Two tones = Voice Controlled (VOX) intercom
Intercom on other side is 2 beeps to alert you that the other side is not
not enabled or off and you available
start speaking
TROUBLESHOOTING
Problem Action
Phone-Related Problems (Driver Unit with Bluetooth Phone)
Unsuccessful Bluetooth Pairing 1. If listed, delete scala-rider from your paired
device list of your phone.
2. Turn off the phone and headset.
3. Remove the battery from the phone, then place
the battery back in the phone.
4. Repeat the pairing process as described above.
I cannot hear stereo sound The two speakers provide only dual mono signals.
Can’t answer calls or perform 1. Make sure that the scala-rider headset is turned
voice dialing by pressing the ON and in standby mode with the blue Status
Control Button Light slowly flashing.
2. Verify that the Bluetooth function on your phone
is set to ON.
12
To Next Page
Loading...
