18
ENG
Gas Leakage Detector +0300047IE rel 1.1 - 26.04.2023
Operation
Bluetooth connection screen:
If all the functions described above have been enabled on the smartphone and the
GLD is in Bluetooth mode, the available devices are shown on the app screen. If this is
not the case, touch the app screen to refresh the display.
Verify that the serial number on the label of the device being connected matches the
one displayed on the screen.
Select the correct device and verify correct connection. The Bluetooth symbol at the
top right changes from red to green.
Home screen:
From the home screen, it is possible to display the current concentration level meas-
ured by the sensor, with the corresponding alarm and warning thresholds.
The following screens can also be accessed:
• PARAMETERS
• MODBUS SETUP
• Test
• Calibration
• More
PARAMETERS screen:
This screen displays the sensor parameters.
It is also possible to select the type of gas to be detected, from those that are com-
patible with the sensor; see the Other information chapter in this manual for further
details.
The following parameters can be displayed and modied if the user is logged with
Technician access
• Warning threshold
• Warning reset: manual or automatic
• Alarm threshold
• Alarm reset: manual or automatic
• Warning relay setting with Fault
• Type of analogue output
• Alarm delay.
• The specic gas to be detected
To Next Page
Loading...
