19
ENG
Gas Leakage Detector +0300047IE rel 1.1 - 26.04.2023
Operation
Modbus setup screen:
the following parameters can be set:
• Modbus address
• Baud rate
• Parity and stop bits.
Pressing SET DEFAULT sets the default parameters shown in the table in the Modbus
setup paragraph.
Test mode screen:
If enabled, the following functions can be activated in test mode, i.e. not correspond-
ing to the behaviour of the device, rather for debugging:
• Warning relay
• Alarm relay
• Green LED
• Red LED
• Yellow LED
• Analogue output.
More screen:
this displays the app technical and legal information.
• App settings, change the unit of measure for the temperature displayed in the app
• Device Info, view information on the currently connected device
• Create report: to make a copy of the most recent report generated
• Change logo, to replace the default logo that is shown on the calibration certicate
with a dierent one
• EULA, to display the app’s legal information
• Third party license, see information on the third-party licenses used.
IMPORTANT: the Calibration screen is explained in detail in paragraph 6.2 CALIBRATION VIA APP.
To Next Page
Loading...
