Content
1. INTRODUCTION 6
1.1 Fullmotion compressor driven by speed control ..................................... 6
2. IR33+ WIDE FULLMOTION 8
3. FULLMOTION SETTINGS 9
3.1 Set point control .............................................................................................. 9
3.2 Speed table configuration ............................................................................. 9
3.3 Defrost ............................................................................................................. 11
3.4 Hot gas defrost .............................................................................................. 11
3.5 Drain heater management ......................................................................... 12
3.6 Temperature Pull Down .............................................................................. 12
3.7 Evaporator fan ............................................................................................... 13
3.8 Continuous cycle ........................................................................................... 13
3.9 Neutral zone & reverse mode .................................................................... 13
3.10 Second compressor ...................................................................................... 14
3.11 Second compressor management ............................................................ 14
3.12 Pump down .................................................................................................... 15
3.13 OFF from keypad .......................................................................................... 15
3.14 Digital input configuration .......................................................................... 16
3.15 Frost protection alarm .................................................................................. 16
3.16 High condenser temperature alarm management.................................17
4. PARAMETER TABLE 18
5. ALARMS RELATED TO FULLMOTION FIRMWARE REVISION 19
6. IR33+ WIDE FULLMOTION START UP PROCEDURE 20
To Next Page
Loading...
